The manufacturer of Fuser gear tells you that laser printers are one of the common office equipment. The manufacturer of Fuser gear tells you that it is necessary for the daily maintenance in place to reduce the chance of printer failure and improve the quality of output paper samples.

1. Electrode wire maintenance
The manufacturer of Fuser gear tells you that due to the residual toner, dust and paper scraps in the printer, the charging, transfer, separation and discharge electrode wires will be contaminated, which will reduce the voltage and affect the normal working performance. Generally speaking, if the charging or transfer electrode wire is contaminated with waste toner, paper dust, etc., the ink color of the printed piece will be insufficient, or even light. This is mainly due to insufficient charging of the toner cartridge after the electrode wire is dirty. Therefore, the voltage of the latent image generated on the toner drum is not enough and the toner absorption is insufficient. The transfer electrode wire is contaminated and the voltage is not enough. When the paper passes by, the contact between the paper and the toner drum is not close enough, and transfer to the paper The toner is not enough, so the ink color of the output paper sample will be too light. The manufacturer of Fuser Gear tells you to clean the drum electrode wire first with a brush to remove the foreign matter attached to it, and then wipe it gently and carefully with degreasing cotton.
2. Maintenance of laser scanning system
The manufacturer of Fuser gear tells you that when the laser and various working mirrors in the laser scanning system are contaminated by dust, etc., the bottom dust of the print will increase and the image will be unclear. They can be wiped clean with degreased cotton, but care should be taken not to change their original position or damage them.
3. Partial maintenance of the fuser
The manufacturer of Fuser gear tells you that the main tips for maintenance of the fuser part are fuser heating roller, pressure roller, separation claw, thermistor and thermal switch.
There are some principles when maintaining the laser printer. When cleaning the visible parts, try to use a dry cloth or a small amount of special cleaning agent. When wiping, do not damage the toner cartridge and other key parts. There are artificial marks to prevent these marks from affecting the output. Make an impact.
When cleaning the circuit part, do not use a damp cloth to wipe it, and at the same time, avoid leaving cloth dust. You can use a silk or professional cleaning cloth to clean. Some connecting wires should also try to prevent touching. Of course, the most important point is to turn off the printer before maintenance.
The manufacturer of Fuser Gear tells you that when using a laser printer, you should choose high-quality printing paper in the selection of paper. This can effectively protect the balance of the roller shaft and other components and prevent problems such as difficulty in paper separation.
In the use of consumables, you should not use inferior consumables cheaply. Because different models have different requirements for consumables, it is best to use matching consumables.
The manufacturer of Fuser gear tells you that when installing or disassembling the laser printer, remember to remove or connect the cable and operate it when the machine is turned off. Do not plug or unplug it when the power is on to prevent the motherboard from burning out. The manufacturer of Fuser gear tells you that if you encounter a paper jam during use, please turn off the power first, then open the cover and slowly pull out the jammed paper. Do not use force to solve it.